1 / 4
Mounting pins for Gunpla Display Arm
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Alternate mount options for the wonderful "Gunplay Display Arm". These should add more kit compatibility.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 462
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (23)Powiązane
This adds several mounting options for the "Gunplay Display Arm" by GunplaMark. If you haven't checked out his make, go take a look, you'll need it to work with these.
- Some of the earlier RG kits used a very specific peg on the Action Base 2. The “Gunpla Dispaly AB2 Peg” file can be used to mount those kits.
- Some of the later RG kits used a bracket that only fits over a very specific mounting pin in the Action Base 5. The “Gunpla Display AB5 Pin” can be used to mount those kits.
- The pin in the original make was really tight, as I found it slightly to large for several kits. The “Gunpla Display AB5 Pin” should work if you're having a similar issue.
Your x and y need to be fairly accurate for these to work well. You should also print at a fairly high quality setting on your slicer to make sure the sizes come out right.
Tested with PLA on a Bambulab P1S.