Combination & Speed Square Wall Mounted Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mounted holder for combination and speed squares.
- Ocena
- 4,75 / 5
- Polubienia
- 67
- Pobrania
- 465
- Wydruki
- 2
- Wyświetlenia
- 1403
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Wall mounted holder for three speed squares and four combination squares. There are two versions and I have only printed V2 file.
V1 - Holders three speed squares and four combination squares. The width is setup around a 7" Milwaukee speed square which was the widest square I had. Most speed squares should fit it may just be a bit wider than necessary. The model has also been updated to be a bit thinner than the original design but it is still probably overkill and could use some massaging to reduce the amount of filament used.
V2 - This was the original design I made for my specific application to allow this to hold a 12" speed square that extends past the end of the wall I have this mounted to. Note that the slots are setup for 12" empire square, 7" Milwaukee speed square, and a 4-1/2" Milwaukee speed square in this application.