Combination & Speed Square Wall Mounted Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wall mounted holder for combination and speed squares.
- Rating
- 4.75 / 5
- Likes
- 67
- Downloads
- 465
- Makes
- 2
- Views
- 1,403
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Wall mounted holder for three speed squares and four combination squares. There are two versions and I have only printed V2 file.
V1 - Holders three speed squares and four combination squares. The width is setup around a 7" Milwaukee speed square which was the widest square I had. Most speed squares should fit it may just be a bit wider than necessary. The model has also been updated to be a bit thinner than the original design but it is still probably overkill and could use some massaging to reduce the amount of filament used.
V2 - This was the original design I made for my specific application to allow this to hold a 12" speed square that extends past the end of the wall I have this mounted to. Note that the slots are setup for 12" empire square, 7" Milwaukee speed square, and a 4-1/2" Milwaukee speed square in this application.