1 / 5
Brewing bulkhead for bung or pipe/blow off tube in a bucket lid — zdjęcie 1
1 / 5

Brewing bulkhead for bung or pipe/blow off tube in a bucket lid

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bulkhead for adding a blow-off tube or bunge to any plastic surface such as the lid for a five gallon bucket. I didn't…

Ocena
0 / 5
Polubienia
18
Pobrania
63
Wydruki
0
Wyświetlenia
517
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Share Alike

Bulkhead for adding a blow-off tube or bunge to any plastic surface such as the lid for a five gallon bucket.

I didn't find anything like this online and I needed it for the top of a blowoff bucket that I was making. It would work as the entry point for a bung or 1" tube on any type of lid/bucket. Along with the body and two nut options, I also uploaded a design for some washers that could be printed in TPU. I didn't personally use the washers because I had some rubber washers left over from some 1" slip bulkheads I had bought off of amazon.

The threads work pretty well, but go together easier if you sand them down a little bit. OpenSCAD files included if you want to make any changes. For changes, you will need the threads.scad library located here https://github.com/rcolyer/threads-scad.

2024.11.17 - Added a version 2. This version was redesigned to seal better on 1 1/4 inch outside diameter tubing that I often use for blowoff tube. The original version didn't allow the tube to pass all the way through and didn't seal well. This one seems to seal better. Also made the body and nut a little bit smaller.

Print Settings

Printer Brand:

Creality

Printer: 

CR-10S

Rafts:

No

Supports: 

No

Infill:

20%

Filament:

Generic PETG 

 

 

Category: DIY

Tagi