1 / 5
Brewing bulkhead for bung or pipe/blow off tube in a bucket lid — image 1
1 / 5

Brewing bulkhead for bung or pipe/blow off tube in a bucket lid

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Bulkhead for adding a blow-off tube or bunge to any plastic surface such as the lid for a five gallon bucket. I didn't…

Rating
0 / 5
Likes
18
Downloads
63
Makes
0
Views
517
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Share Alike

Bulkhead for adding a blow-off tube or bunge to any plastic surface such as the lid for a five gallon bucket.

I didn't find anything like this online and I needed it for the top of a blowoff bucket that I was making. It would work as the entry point for a bung or 1" tube on any type of lid/bucket. Along with the body and two nut options, I also uploaded a design for some washers that could be printed in TPU. I didn't personally use the washers because I had some rubber washers left over from some 1" slip bulkheads I had bought off of amazon.

The threads work pretty well, but go together easier if you sand them down a little bit. OpenSCAD files included if you want to make any changes. For changes, you will need the threads.scad library located here https://github.com/rcolyer/threads-scad.

2024.11.17 - Added a version 2. This version was redesigned to seal better on 1 1/4 inch outside diameter tubing that I often use for blowoff tube. The original version didn't allow the tube to pass all the way through and didn't seal well. This one seems to seal better. Also made the body and nut a little bit smaller.

Print Settings

Printer Brand:

Creality

Printer: 

CR-10S

Rafts:

No

Supports: 

No

Infill:

20%

Filament:

Generic PETG 

 

 

Category: DIY

Tags