1 / 4
XBOX Controller Soft Joystick Covers
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
TPU replacements for the soft rubber covers on XBOX controllers or similar handheld controllers.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 412
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
I've long had issues with rubber wearing off of XBOX controller joysticks after a period of time. I created this model to replace the worn away rubber with a TPU cover.
Print Information
Material: TPU 95A*
Nozzle Diam: 0.40mm
Layer Height: 0.10 mm
*Be sure to verify that the print bed you plan on using is appropriate for TPU.
Installation Instructions
- Cut away any remaining rubber with a utility knife.
- Clean the area with a dremel wire wheel (Optional, but useful to be sure any of the old material is gone).
- Clean joystick surface with IPA. Be sure surface is free of dust or debris.
- Apply super glue to the top surface.
- Slip the two printed halves of the soft cover onto the joystick.
- Hold halves in place for approximately 30 seconds or until super glue cures.