1 / 2
20cm to 17mm Funnel (for e.g. Silica Gel beads)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple no-supports-needed funnel that can be used to pour silica beeds without getting clogged easily.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 233
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (12)Powiązane
Wall thickness is 2mm, top diameter is 200mm, bottom is 17mm, neck height is 20mm.
Prints without supports. Recommended to print in PLA, PETG should work fine as well.
I created this to pour Silica gel from an oven tray where I dried it into a container. Dry silica gel beads are very bouncy so a wide opening is needed and easily clog smaller funnels so a wide bottom is also helpful.