1 / 2
20cm to 17mm Funnel (for e.g. Silica Gel beads)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a simple no-supports-needed funnel that can be used to pour silica beeds without getting clogged easily.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 72
- Makes
- 0
- Views
- 233
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Wall thickness is 2mm, top diameter is 200mm, bottom is 17mm, neck height is 20mm.
Prints without supports. Recommended to print in PLA, PETG should work fine as well.
I created this to pour Silica gel from an oven tray where I dried it into a container. Dry silica gel beads are very bouncy so a wide opening is needed and easily clog smaller funnels so a wide bottom is also helpful.