Wyze Sense v1 Contact Sensor Mount Set
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adaptation of wyze sensor mounts by @aaronroma - thingiverse, let's me end mount the sensor trip magnet w/o double stick
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 110
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
updated - 8/24 - v1 again - this is a scratch build using the prior versions to create the sensor blank then redesigned around that.
thickened outer shell, reduced retention size and reduced to 1, reduced mount holes to fit #4 miter screws, reduced reset hole diameter added undercut miter to base to ease removing from holder.
Updated - V5 - Added sensor & retention tabs - left in the files, just in case
After a month or 2 of using old wyze sense v1 contact sensors on newly constructed overlay custom cabinet doors where I had to orient the magnet section rotated 90 on the vertical axis stuck on with double stick tape…just wasnt holding all that well, also had the sensor side pull from the wall on a couple built in place storage shelves, I decided a mounting shell for the sensor parts would be better.
After searching them up, seems no one mounts the way I need to, so to save time & protoyping, did a mashup/remix of an existing set.
Figured adding sensor reset probe hole was a good plan just in case, and of course the end wall screw hole for the magnet catch.
taz4 60c bed, 205c hot end using 2.85 matt black polymaker PLA sliced with Taz cura set for high detail, 2 wall, 3 face, 25% infill with short side slice termination.
Printer was set for 95% feed rate.