Power supply w offset power cord mount bracket (for DC variable speed pumps) 2.3 x 1.25 x 5.25+
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
wall or grid board mountable power supply bracket w M3 miter screw holes, open design for ambient flow cooling
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 227
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
designed to hold the 2.3x1.25 ac to dc power bricks common to computers & other electronics.
Offset plug space on bottom of bracket (possible able to hold center mount plugs if inserted power cord end up - YMMV)
Made the bracket well ventilated since it will already be in a weathertight demarcation case used to control pond & hothouse devices.
I went for a balance of passive ventilation & solid support.
Intended for use with hex drive miter head M3 machine screws.
Also wall mountable using #6 miter head wood screws.
Printed on my taz4 60c bed, 205c hot end using 2.85 matt black polymaker PLA.
Printer was set for 85% feed rate.
Orient upright with offset port on printer baseplate.
gcode output (in zip file) Taz cura set for fast, 2 wall, 3 face, 10% infill with short side slice termination.
I recommend you set to fine, with 90% feedrate
I printed 2 at once, took about 5.5 hours on fast, only slightly less time printing just 1.
On fine print on taz4 would be over 7 hours.
I was able to print without supports with minimal crudding on fast print, fine should print very cleanly without supports.