Sunlu S2 Desiccant Dryer Basket (M3 Remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Desiccant dryer basket to fit the Sunlu S2 filament dryer for loose desiccant or desiccant packets.
- Ocena
- 4,667 / 5
- Polubienia
- 50
- Pobrania
- 241
- Wydruki
- 5
- Wyświetlenia
- 1708
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I loved the original design but remixed it to change the alignment posts into holes sized for M3 screws.
For the full model, you'll need to print two of the side plates. I printed the original model out PETG and glued it with CA glue. After a couple uses, I noticed the glue seam beginning to come apart. Concerned that I might end up with desiccant spilling all over at some point, I remixed the model to allow reinforcement with M3 screws. When I printed my M3 remix, I also printed it with ABS. I would recommend this (or ASA) for the higher temperature resistance and stronger bond with CA glue. As with the original model, the tub and lid have spaces for 4mm x 2mm magnets to hold the lid on.
For assembly, M3-10 or slightly longer screws are best. This allows you to start the screws (for alignment) and leaves a large enough gap to apply the CA glue. See image below. It's also best to thread the screws all the way in and take them back out before applying glue. This will make it easier to screw everything together after your apply the glue. After screwing it all together, I still added clamps in between the screw locations and at the top edge to keep good alignment and get a strong bond.
