IKEA Replacement bed slat bolt and sleeve, 104850 & 105160
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Plastic self locking bolt and sleeve assemblies for an IKEA Kura bed, and perhaps other IKEA furniture
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 257
- Wydruki
- 3
- Wyświetlenia
- 1071
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed one of these plastic self locking bolt and sleeve assemblies for an IKEA Kura bed I bought thirdhand, that was missing some. So I took out one good one, measured and modeled up a similar design. Printed with 0.4mm nozzle in PETG at 0.1mm thickness, for thread resolution. The sleeve part has a cone inside to spread the threaded legs on the bolt part, locking it in place just like the original.
They are NOT oriented correctly for printing, so just make sure the flats go down, and they will print fine without supports. These are small parts, so printer slower is better.
Print Settings
Printer Brand:
ELEGOO
Printer:
ELEGOO NEPTUNE 4 Pro
Rafts:
No
Supports:
No
Resolution:
0.1mm
Infill:
20%-100%
Filament: 3DHOJOR™ PETG Grey
Category: Replacement Parts