dragon effector v400/SuperRacer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
remix of https://www.thingiverse.com/thing:4734896 (Other parts can also be found here) 4 walls min top/bottom 3mm…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 427
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
remix of https://www.thingiverse.com/thing:4734896
(Other parts can also be found here)
4 walls min
top/bottom 3mm
infill gyroid / grid
supports bottom only
known materials minimum petg
ideally abs , polycarb, petgcf , pa6
support stock probe ensure this is square to the nozzle
recommended probe (nozzle direct)
probe wire clips https://www.thingiverse.com/thing:5940041
Top cutout is for adxl
balls simply push in may need to use a screw driver to slightly adjust hole
optional loctight blue on ball stems
4010 fans screws or super glue / contact cement either will work
Hotend mount either screws and, bolts or B 3mm brass inserts x2
Note holes will need a small adjustment for inserts
current ducts wip
if needed to adjust size simply lower a bit below build plate in slicer or "plane cut"
individual duct.stl if used multiply it in slicer and, mirror.
/
Category: 3D Printing