Monster Outdoor LED Strip Mounts For Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small clips to hold the monster brand outdoor LED strip.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Small clips to hold the monster brand outdoor LED strip (or any led strip with a width of [width] and a depth of [depth]) I found this strip for cheap at my local Ollie's bargain outlet and the control box broke, so I decided to cut it off and install a buck converter to run them off the printers built in power supply. I set the buck converter to 12v and solder the “+” side across the RGB solder pads(in parallel) and the “-” side to the neutral solder pad so each color gets 12v.
I would recommend printing in PETG for extra flexibility and temp resistance in the case that you print high temp polymers with a high chamber temp. though PLA should still work.
I printed 6 so that there were 2 clips per side. I used 15% Cubic infill and 3 perimeters. I also used .3mm layer height with a .4mm nozzle.
I wouldn"t recommend snapping the clip onto the pole, as the clip will probably break. I'd advise removing the poles from the enclosure joints and sliding them down the pole