Monster Outdoor LED Strip Mounts For Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Small clips to hold the monster brand outdoor LED strip.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 14
- Makes
- 0
- Views
- 128
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Small clips to hold the monster brand outdoor LED strip (or any led strip with a width of [width] and a depth of [depth]) I found this strip for cheap at my local Ollie's bargain outlet and the control box broke, so I decided to cut it off and install a buck converter to run them off the printers built in power supply. I set the buck converter to 12v and solder the “+” side across the RGB solder pads(in parallel) and the “-” side to the neutral solder pad so each color gets 12v.
I would recommend printing in PETG for extra flexibility and temp resistance in the case that you print high temp polymers with a high chamber temp. though PLA should still work.
I printed 6 so that there were 2 clips per side. I used 15% Cubic infill and 3 perimeters. I also used .3mm layer height with a .4mm nozzle.
I wouldn"t recommend snapping the clip onto the pole, as the clip will probably break. I'd advise removing the poles from the enclosure joints and sliding them down the pole