1 / 1
Lily58 Case for Typeractive.xyz Choc Kit
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fully 3D-printable case for the Typeractive.xyz Lily58 kit, with more-compact switch spacing than the original Lily58
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 305
- Wydruki
- 0
- Wyświetlenia
- 1882
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 0) (Komentarze: 3)Remiksy (0)Kolekcje (39)Powiązane
This is a remix of @Joshckb_190777's excellent Lily58 case adapted to fit the Typeractive.xyz Lily58 Choc kit, which uses a more-compact switch spacing than the original Lily58 board.
This only fits the Typeractive version of this board with Choc switches! If you have a Cherry kit from Typeractive or a Cherry or Choc kit from any other supplier, this will not work for you!
Recommended print settings:
- Layer Height: 0.2mm
- Nozzle: 0.4mm
- Several features on the top plate are quite small with tight tolerances and larger nozzles are likely to interfere with the switch interface.
Assembly is straightforward, you may attach the two halves either
- Using 5x 8mm M2 countersunk screws + 5x M2 4x3.2mm threaded inserts. This provides the most robust mounting interface. I used the inserts from this set, although any should work if the height is < 4.5mm and the outer diameter is 3.2mm or less.
- Using 5x 8mm M3 countersunk screws screwed directly into the top plate from the bottom. This requires no hardware other than the screws, but the top mating interface is quite fragile and easy to break the screw hole.