Hillside 48 Two-Part Keyboard Case (with Variants)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A new two-piece case for the Hillside 48 keyboard, with build variants and travel cover.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 261
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
A new Hillside 48 case family that includes variants for any combination of:
- Accessory cutout Yes/No
- Power Switch cutout Yes/No
- TRRS jack cutout Yes/No
- Shadowline Yes/No
Find the variants in the appropriate zips. Naming convention should be clear, as it follows the structure in the list above.
Note that all variants say “M Cov” at the front because there is a version with the MCU uncovered, but it's not regenerating nicely atm and uploading those variants would mean generating another 16 variants and uploading them. If someone wants such a variant, just message me lol.
The cases are meant to screw together from the bottom into the plastic of the top using M2 screws in the holes outside of the PCB footprint. You can screw the PCB to the bottom first, if you like, using some of the mounting holes in the middle of the case. You might find that some or all of these screws are irrelevant and things hold together okay for desk use with only some or none of them. Depends on your printer's settings and tolerances and how rough you are on your boards lol.
I've also included an (untested!) travel cover for the family. It should fit nicely on chocs with typical caps, but idk. Let me know if you have any problems with these cases, or want a particular variant board (e.g., 42 key snap-off with power switch cutouts and shadowline).