1 / 8
Baofeng UV-5R Radio Cradle Mountable with Charging — zdjęcie 1
1 / 8

Baofeng UV-5R Radio Cradle Mountable with Charging

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a tight fit cradle for Baofeng UV-5R radios with contact charging.

Ocena
0 / 5
Polubienia
22
Pobrania
108
Wydruki
0
Wyświetlenia
743
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial

This is a tight fit cradle for Baofeng UV-5R radios with contact charging. You can install the charging contacts out of the charging cradle the radio comes with. You will need to solder the USB charging cable that also comes with the radio as shown in the photos. 

The contact charging leads and the cable cover screws in with M2 screws.

The charging cradle is meant to be mounted via the two ears on the side. These are raised on the mounting surface so it can be mounted on any sloped or uneven surfaces (only 2 contact points). 

The cradle also has two slots up front and rear to attach an optional secondary hook and loop type retention. The cradle is so tight, this is not necessary most of the time.

Recommend using PETG or other higher temp material if installing into a car.  PLA will be fine for climate-controlled locations.

 

This is what worked well for me:

0.4mm nozzle, 0.2mm layer, PETG, no supports
Cradle: 4 top shell layers, 4 bottom shell layers, 4 wall loops, 25% gyroid infill.
Cover: 2 top shell layers, 2 bottom shell layers, 2 wall loops, 15% gyroid infill. 

Tagi