1up Wrench / Allen Wrench Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a a very tight fitting handle for a 1UP wrench or resized for any other allen wrench.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 45
- Wydruki
- 1
- Wyświetlenia
- 326
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Currently sized at 9.6mm wide on the flat to flat inner dimension.
I printed this at a very tight fit in PLA+ to be a permanent addition to my wrench handle. Given I was down to the last few wraps on the spool of filament, I printed it at a single wall at 10% gyroid for a 4g print. 0.28 layers and inner+outer brim for stability in vertical print orientation.
If you're concerned about fit, I'd print only 2-3 mm of the print and stop there. Use the partial print as a calibration piece and size up (or down) accordingly.