1 / 7
Eclipson Model S FPV canopy
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lightweight FPV canopy for Eclipson Model S. Designed for DJI O3 unit, but any vista should fit too.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 324
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
FPV canopy for Eclipson Model S. Designed for DJI O3 unit, but any vista should fit too.
Features:
- 9g servo mount for pan
- holes to zipties
- O3 antenna mount
- Secure canopy in place using M4 bolt
Pan tilt system is not included. Camera mount is not included too!
How to print:
- !!!! USE BRIM !!!! or canopy can detach from build plate mid print. Contact surface is very small.
- Orient both canopy pieces so they stand vertically.
- No supports needed.
- Print both canopy pieces with your eclipson A/LW profile (single wall, no infill, 1 top 1 bottom layer)
- Print holder.stl with 3 walls, 30% infill, 3 bottom 3 top layers. Make sure its bottom surface lays flat on the build plate!
I used esun PLA+ for all canopy pieces but you can use any filament you want. For O3 air unit, i would recommend using something that can resist its high temperatures.