Ender S1 Pro Fan Shroud(duct) upgrade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
So the cooling fan/mount on the S1 pro is horrible. Here is a very simply upgrade, Simply remove the fan, flip the…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 476
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
So the cooling fan/mount on the S1 pro is horrible. Here is a very simply upgrade,
Simply remove the fan, flip the stainless steel bracket 180 degrees and mount back with two of the mounting holes.
Obviously after you have printed and replace the fan shroud.
No need to upgrade any fan, just make sure you undo the cable relief behind the fan and it will still reach the connector port as expected.
You will see once the new shroud is in place the nozzle is slightly off center. this is expected. one port of the shroud points at the printed point, and the other at the area just off the side. meaning the melted plastic gets blast of air just as its laid down, and another blast when head moves past that point.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 v2
Rafts:
Yes
Supports:
Doesn't Matter
Resolution:
0.2 or 0.28
Infill:
100%
Filament: Generic PLA black
Notes:
Print on fan vent ports like image below with Brim, I didnt need support but you might.
Category: 3D Printers