1 / 3
QFH Antenna 419Mhz(433Mhz Band)  2-Parts — zdjęcie 1
1 / 3

QFH Antenna 419Mhz(433Mhz Band) 2-Parts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

419mhz Center Freq. Hope the bandwidth is good. This was model 100% to a the calculations of online calculations to…

Ocena
0 / 5
Polubienia
23
Pobrania
191
Wydruki
0
Wyświetlenia
1328
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

419mhz Center Freq. Hope the bandwidth is good. This was model 100% to a the calculations of online calculations to the 0.5mm. Going to be intresting to see calculation vs result. I suspect the plastic will have effect but since center is 419mhz should not be to bad.

This should make it easy for anyone to even make it out of twinflex stranded copper.

NOTE: The print was broken into two parts to help print in sections,

Print Top section Right side up..

Print Bottom Section Upside down

https://www.youtube.com/channel/UCOF4Weyd86jnmXrSXUu6xHg https://www.youtube.com/channel/UCx3vuuvTi2mlCWkdZUr-bow

Print Settings

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2

Infill:

100

Filament: WhoCares PLA

Notes:

419mhz Center Freq. Hope the bandwidth is good. This was model 100% to a the calculations of online calculations to the 0.5mm. Going to be intresting to see calculation vs result. I suspect the plastic will have effect but since center is 419mhz should not be to bad. Will be testing this week and happy to post files. This should make it easy for anyone to even make it out of twinflex stranded copper.

Post-Printing

QFH Antenna

Category: Electronics

Tagi