1 / 3
QFH Antenna 419Mhz(433Mhz Band)  2-Parts — image 1
1 / 3

QFH Antenna 419Mhz(433Mhz Band) 2-Parts

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

419mhz Center Freq. Hope the bandwidth is good. This was model 100% to a the calculations of online calculations to…

Rating
0 / 5
Likes
23
Downloads
188
Makes
0
Views
1,315
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

419mhz Center Freq. Hope the bandwidth is good. This was model 100% to a the calculations of online calculations to the 0.5mm. Going to be intresting to see calculation vs result. I suspect the plastic will have effect but since center is 419mhz should not be to bad.

This should make it easy for anyone to even make it out of twinflex stranded copper.

NOTE: The print was broken into two parts to help print in sections,

Print Top section Right side up..

Print Bottom Section Upside down

https://www.youtube.com/channel/UCOF4Weyd86jnmXrSXUu6xHg https://www.youtube.com/channel/UCx3vuuvTi2mlCWkdZUr-bow

Print Settings

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2

Infill:

100

Filament: WhoCares PLA

Notes:

419mhz Center Freq. Hope the bandwidth is good. This was model 100% to a the calculations of online calculations to the 0.5mm. Going to be intresting to see calculation vs result. I suspect the plastic will have effect but since center is 419mhz should not be to bad. Will be testing this week and happy to post files. This should make it easy for anyone to even make it out of twinflex stranded copper.

Post-Printing

QFH Antenna

Category: Electronics

Tags