Light Mount Ender 3 V3 SE
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A light mount that goes up and down with the Z axis.
- Ocena
- 4,667 / 5
- Polubienia
- 85
- Pobrania
- 309
- Wydruki
- 3
- Wyświetlenia
- 4061
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix of a very nice comcept of a lightbar that moves with the Z axis.
If you like my model, please consider -> https://buymeacoffee.com/teacherribeiro
If you like my model cheCk my 4010 mount for ender 3 V3 SE
Printing configurations:
PLA
0.2 layer height
10% infill
3 perimeters
support organic on build plate only, but you may block some spots and enforced others (see images bellow)
You can also use this image for printing orientaition.
Bill of material:
2x led strips of 20cm each
4x m3*28 (I used 2 and was great)
1x LM2596
on/off switch
wires
I conect the original power suply to the DC-DC conversor so I can get 12V for the LED strips.
The LM2596 is cased inside the printer using the original screw, as the image bellow. (The original LM2596 mount is here)
The wiring passes through the holes at spine cable chain
