1 / 5
Fox 36/38 Grip2 Dial
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom High Speed Compression dial for Fox 36/38 Grip2.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 173
- Wydruki
- 4
- Wyświetlenia
- 1520
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 4) (Komentarze: 6)Remiksy (1)Kolekcje (31)Powiązane
I wanted to black out the dials on my Fox 36, so I created this!
Allows for colour customisation of the HSC dial and Aircap, also tested with a Fox 38.
My print settings:
- PLA (use any filament/colour you like!)
- 0.1mm layer height
- Simple supports, manually placed on the flat bottom parts of both the dial and cap (avoid support in the Schrader Valve)
Supports painted on:
Grip2 dial:
When disassembling the original Grip2 dials, beware of the small sprung ball bearings.
- Loosen the retaining bolt for the damper dials and carefully remove them.
- Remove the ball bearings and springs using a small needle or nail, don't lose them!
- Transplant the springs into the corresponding holes in the model.
- Using a screw driver or similar pack the springs/holes with plenty of grease, this is needed to ‘stick’ the ball bearings into the holes for installation.
- Insert the bearings and carefully place the LSC/HSC stack into the bike. Rotate until the dials bottom out on the damper.
Air Cap:
The printed threads will work with the air valve, beware of cross threading on first install.
Enjoy your pimped out bike!
PS: Check out my remix for the latest GripX dial variations!