Nintendo Switch Game Case and JoyCon strap holder

A 6 game case for the Nintendo Switch that also holds your JoyCon straps while utilizing them as a locking mechanism and enabling easy cary of the case.

The current version was designed to work well on all printers and is actually a bit loose on my mk3s because this thing prints so well. I will upload a version with slightly tighter tolerances in the near future.

Print instructions

These files can be used with the MMU(2) but a 2 color print can be achieve without it. I print the logo bits by themselves and then program in a color change in slicer at the layer where bridging over the logo gaps starts. If your print is good enough the inserts should sit right in and get printed into the final model. I have also put a bit of glue stick on the surface of the inserts before placing them in just to make sure they stay in place while the bridging seals them in place.

Also supports are only necessary for the one vertical rail. As such I like to turn on supports but set the angle to like 89 so they are only generated under the floating rail. Also "bed only".

I usually Print these at .2mm Higher res can lead to a nicer finish on the outer curve but lower res actually provides more grip on the games themselves. Changing resolution at height is possible to achieve both.

20% infil is fine though I prefer the feel of 100%.