Anti-rotate Multiconnect
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Multiconnect disk for Multiboard that doesn't let the object being attached to rotate, so only one is needed per item.
- Ocena
- 4,875 / 5
- Polubienia
- 88
- Pobrania
- 878
- Wydruki
- 8
- Wyświetlenia
- 2162
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Born out of necessity, I present to you all the Anti-Tilt MultiConnect! Snap it into your Multiboard (square side down) and enjoy attaching small MultiConnect parts without needing two MultiConnectors to keep the item from rotating!
20% infill
No supports
fits very tight, because of the increased surface area, but this also keeps small parts from being lifted off too easily. A looser fit could be accomplished by sanding/filing the edges, or potentially even sizing the whole part down (the snap fits really tight too).
Enjoy, and don't forget to post your makes!