Dart XL - Runcam Split Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple part made to fit the Runcam Split (I'm using V2 here) into the Dart XL from ZOHD. It fits snugly into…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 271
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple part made to fit the Runcam Split (I'm using V2 here) into the Dart XL from ZOHD. It fits snugly into the nose like the included foam inserts for different cameras, and the Split mounts into it. There are openings to allow airflow into the nose for cooling batteries, as well as some air flowing over the Split's main board as well. It mounts the Split's imager far enough forward to get the lens out in front of everything for a clear view.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
No
Supports:
Yes
0.2
Infill:
25%
Notes:
Print face down, you may need supports under the two bridges behind the cutouts for airflow. I printed without supports and it did fine. I printed it with PETG, but PLA should be fine also. You may need to clean out the holes for the screw that mount the camera/imager, depending on how bad the filament sags when printing them. The holes for mounting the main board should allow M3 screws to thread into them snugly.
Category: R/C Vehicles