Koh-I-Noor Rapidomatic mechanical pencil cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A friction fit cap to protect the pencil end from breaking or prevent the pencil tip from poking a hole in something
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This cap will protect the writing end of the Koh-I-Noor Rapidomatic mechanical pencil. It's a friction fit design. There are two versions and both work well. I'd recommend using the one with the cut. It will expand to fit the pencil. After printing, you may need to put it on and off a few times to allow the plastic to adjust
This is for a Koh-I-Noor pencil made in February of 2024. I don't know if it will fit older pencils that have a different knurling or diameter tip. It will fit pencils with all lead sizes.
Versions: (2) One with a cut so it expands to fit and one that does not have the expansion cut.
Printer settings
Material
PLA, any other plastic should be fine
Quality
.15mm
Infill
100%
Brim
Yes
Supports
No
Print with a brim, and clean up with an xacto as needed.