Soldering station & brass wool holder for Pinecil/TS100
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Soldering station with brass wool holder for Pinecil/TS100 or similar soldering pen
- Ocena
- 4,5 / 5
- Polubienia
- 38
- Pobrania
- 155
- Wydruki
- 2
- Wyświetlenia
- 835
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Soldering pen and brass wool holder. Fits Pinecil, TS100, or similar soldering pens
Printed in PLA. Balanced, no weights needed.
3 hour 20 minutes print on an Ender 3 V2.
Hardware:
8mm ball bearing(608, 22mm outer diameter) for soldering pen holder
(Or 22mm washers).
Brass wool
M2 screw(optional)
Specifications:
95x95x67mm.
60mm diameter sphere.
50g weight 100% infill PLA.
Recommended settings:
0.20-0.25 layer height(0.25 in pictures)
100% infill for good weight
3 walls for faster print
No supports needed but underside of pen holder might look visually messy.(No supports used in pictures)
Slight tendency to warp, small brim if your setup has issues with warping.(No brim used in pictures)
Small hole for M2 screw to fasten ball bearing, but press fit has worked fine.