1 / 1
Alberto knot - fishing knot tool with support legs and TPU corner inserts updated — zdjęcie 1

Alberto knot - fishing knot tool with support legs and TPU corner inserts updated

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simplifies tying alberto knots

Ocena
0 / 5
Polubienia
11
Pobrania
164
Wydruki
1
Wyświetlenia
1241
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Had this uploaded before but deleted it after noticing a bunch of small issues with it after a test print especially the corners not holding line properly. All is good now though after removing the winged cutouts in the main body. 

 

I printed the main body and support legs in ASA - 10 to 20 percent triangular infill (it's up to you though). Supports are required for the main body as the overhang is a bit much. 

The corner inserts should be printed out of TPU. I used 95A TPU. Superglue them in place. 

Support legs fit snugly and can be placed in the center cavity when not in use. The walls in the cavity should hold it just snug enough but not be difficult to pop out. 

Printed everything using .16mm layer height. 

Tagi