Alberto knot - fishing knot tool with support legs and TPU corner inserts updated
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simplifies tying alberto knots
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 164
- Makes
- 1
- Views
- 1,241
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Had this uploaded before but deleted it after noticing a bunch of small issues with it after a test print especially the corners not holding line properly. All is good now though after removing the winged cutouts in the main body.
I printed the main body and support legs in ASA - 10 to 20 percent triangular infill (it's up to you though). Supports are required for the main body as the overhang is a bit much.
The corner inserts should be printed out of TPU. I used 95A TPU. Superglue them in place.
Support legs fit snugly and can be placed in the center cavity when not in use. The walls in the cavity should hold it just snug enough but not be difficult to pop out.
Printed everything using .16mm layer height.