Super Low Profile TUSH - Spool Holder (30x10cm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is designed for Colorfabb 2.2kg spools (same as Prusa 2KG NGEN spool). They have a 30cm diameter and 10cm width.…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 141
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is designed for Colorfabb 2.2kg spools (same as Prusa 2KG NGEN spool). They have a 30cm diameter and 10cm width. Feel free to ask for a specific size if you like the design.
After having tried a few TUSH designs, I found that they are generally a little unstable and will sag under heavy load. I also needed as low a profile as possible.
I designed this to be stronger than you'll ever need and run smooth while avoiding sag after long term use. The spool sits 3mm above the floor.
Print 1 main body and 4 bearing holders.
You need the following to put it together:
4x 608 Bearing
4x M4 nut
4x M4x18 (or longer)
4x M4 washer (no required)
UPDATE 31.08.2018 - I smoothed out the design of the holder and reduced the plastic used quite a bit while maintaining the rigidity
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Category: 3D Printer Accessories