1 / 2
Vernier Calliper 2020 Bracket (with the power of magnetism) — zdjęcie 1
1 / 2

Vernier Calliper 2020 Bracket (with the power of magnetism)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is just a quick remix of a remix of the Bracket vernier calliper (Peg mount)…

Ocena
0 / 5
Polubienia
4
Pobrania
23
Wydruki
1
Wyświetlenia
271
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

This is just a quick remix of a remix of the Bracket vernier calliper (Peg mount) (https://www.thingiverse.com/thing:2866877) by ArneBanane

I updated a 3rd version to add some more clearance for the head of the screw used to install it - it is now about 3.4mm deep which should allow a round head M4 hex screw to be used without it protruding and hitting the caliper.

I made one that attaches to peg board but I also wanted one to mount on the printer since I have a few of these and want one handy in a few places. It is a work in progress until I print it out. Just like the peg board version, there is a place to put a 8mm x 3mm cylindrical magnet in the back of it to help hold the calipers in place. I normally use Gorlilla Glue to do that but any good plastic glue would work. You can find the magnets at Amazon by searching for B0714KZP5C.

For a better finish, it is best to flip the part over when printing.

Print Settings

Notes:

Flip it over

Category: 3D Printer Accessories

Tagi