Redragon K587 Keyboard Light Covers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic covers for the always-on RGB lighting on the sides of the Redragon K587 keyboard.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
- Use 5(diameter) x 2(height) mm magnets.
- Use the “Pause at layer height” script in Cura to pause just before the magnet holes get covered.
- Place the magnets in the hole and resume the print.
I printed it in TPU but should work fine in PLA or anything else.
Paint/print it black for maximum light blockage.
Note: Your nozzle or another part on your extruder might attract the magnets depending on the material it's made of so be sure to check that before hand. Did not happen in my case but something to keep in mind. If that were to happen I would probably use generous amounts of glue to keep it in place. Mine in fact got attracted to the bed which was actually good to have.
Had to make the holes a bit bigger for PETG, will share file when I can.