XL Hamster Laufrad mit optionaler Erhöhung / XL hamster wheel with optional elevation
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
XL Hamster Laufrad mit optionaler Erhöhung / XL hamster wheel with optional elevation
- Ocena
- 1 / 5
- Polubienia
- 26
- Pobrania
- 190
- Wydruki
- 1
- Wyświetlenia
- 1257
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
XL Hamster Laufrad mit optionaler Erhöhung
Hamsterlaufrad in 25cm Durchmesser. Mit der Verlängerung kann man das Rad auf den festen Boden stellen und dazwischen noch Streu packen, dann steht es stabiler und es sieht schöner aus.
Zusammengebaut wird es mit einer M8 70mm Gewindeschraube (13er Kopf) inkl. Mutter
Für die optionale Verlängerung braucht man zusätzlich noch eine M8 30mm und eine M8 90mm Gewindeschraube inkl Muttern natürlich.
zb. hier:
https://www.ebay.de/itm/175430120489
Zusätzlich für die Lagerung werden zwei 608Z Lager benötigt (22mm x 7m) in den Außenmaßen
zb. diese hier:
https://www.ebay.de/itm/313511223718
Zusammengebaut wird es wie auf der Explosionszeichnung.
Die kleine Unterlegscheibe kommt zwischen Schraube und das Lager im Inneren des Laufrades, damit die Schraube nicht das Lager festsetzt.
Man kann auch etwas Schraubensicherung auf die Mutter schmieren oder direkt selbstsichernde Muttern verwenden.
____________________________
XL hamster wheel with optional elevation
Hamster wheel with a diameter of 25 cm. With the extension you can place the wheel on the solid floor and put litter in between, then it is more stable and looks nicer.
It is assembled with an M8 70mm threaded screw (13mm head) including nut
For the optional extension you also need an M8 30mm and an M8 90mm threaded screw incl. nuts of course.
e.g. here:
https://www.ebay.de/itm/175430120489
In addition, two 608Z bearings are required for the bearing (22mm x 7m) in the external dimensions
e.g. these here:
https://www.ebay.de/itm/313511223718
It is assembled as shown in the exploded view.
The small washer is placed between the screw and the bearing inside the impeller to prevent the screw from seizing the bearing.
You can also apply some threadlocker to the nut or use self-locking nuts directly.