1 / 12
Cooling Fan/Shroud with 4cm Blower and Sensor for Wanhao D6/Ultimate — zdjęcie 1
1 / 12

Cooling Fan/Shroud with 4cm Blower and Sensor for Wanhao D6/Ultimate

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This shroud is printed in two parts that slide together. Included is a M12x1mm nut for the proximity sensor. You also…

Ocena
0 / 5
Polubienia
2
Pobrania
21
Wydruki
0
Wyświetlenia
507
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This shroud is printed in two parts that slide together. Included is a M12x1mm nut for the proximity sensor. You also need to print two of the 5x6mm posts and remove a small bridge between the holding posts for the fan on the shroud.

I used a GDStime Technology 24V 0.1A 40mm blower. At 100% the output is about what a 50mm blower (http://www.thingiverse.com/thing:2235389) does at 25-30%.
2x 10mm M2 and 2x 12mm M2 and nuts to fix the Fan in place

The probe is the Omron Manufacturer Part #: E2B-M12KN08-WP-B1 2M which is PNP and it works with a 7805 to reduce voltage down to 5V and the PNP Configuration.h of the Marlin duplicator 6 firmware. This probe has a working distance of 8mm in a M12 form factor. Screw the probe in so that it is flush with the bottom of the shroud. This setup works with a 1mm PEI sheet glued on the build plate.

Same position as in 1bigpig's probe mount http://www.thingiverse.com/thing:2081168 where you also find the description on how to set up the probe.

Empiricus@Dremomys

Print Settings

Supports:

Yes

Resolution:

0.150mm

Infill:

70


Notes:

PETG

Category: 3D Printer Parts

Tagi