1 / 12
Cooling Fan/Shroud with 4cm Blower and Sensor for Wanhao D6/Ultimate — image 1
1 / 12

Cooling Fan/Shroud with 4cm Blower and Sensor for Wanhao D6/Ultimate

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This shroud is printed in two parts that slide together. Included is a M12x1mm nut for the proximity sensor. You also…

Rating
0 / 5
Likes
2
Downloads
21
Makes
0
Views
507
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

This shroud is printed in two parts that slide together. Included is a M12x1mm nut for the proximity sensor. You also need to print two of the 5x6mm posts and remove a small bridge between the holding posts for the fan on the shroud.

I used a GDStime Technology 24V 0.1A 40mm blower. At 100% the output is about what a 50mm blower (http://www.thingiverse.com/thing:2235389) does at 25-30%.
2x 10mm M2 and 2x 12mm M2 and nuts to fix the Fan in place

The probe is the Omron Manufacturer Part #: E2B-M12KN08-WP-B1 2M which is PNP and it works with a 7805 to reduce voltage down to 5V and the PNP Configuration.h of the Marlin duplicator 6 firmware. This probe has a working distance of 8mm in a M12 form factor. Screw the probe in so that it is flush with the bottom of the shroud. This setup works with a 1mm PEI sheet glued on the build plate.

Same position as in 1bigpig's probe mount http://www.thingiverse.com/thing:2081168 where you also find the description on how to set up the probe.

Empiricus@Dremomys

Print Settings

Supports:

Yes

Resolution:

0.150mm

Infill:

70


Notes:

PETG

Category: 3D Printer Parts

Tags