1 / 3
Wanhao D6/Monoprice Drive Block for Flexible Filaments — zdjęcie 1
1 / 3

Wanhao D6/Monoprice Drive Block for Flexible Filaments

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Another take on a drive block for the extruder of the Zortrax/Wanhao D6/Monoprice Ultimate clonage for flexible…

Ocena
0 / 5
Polubienia
9
Pobrania
24
Wydruki
0
Wyświetlenia
293
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Another take on a drive block for the extruder of the Zortrax/Wanhao D6/Monoprice Ultimate clonage for flexible filaments.

Version 2 has a very tight fit for the 10.8mm diameter, 38 tooth Robotdigg Filament drive gear 4 flat shaft for nema17 stepper (RDGFDB) and the Micro-swiss lever for the Wanhao D6. The original D6 drive gear will also fit. The Robotdigg gear has wicked sharp teeth and thus much better retraction abilities compared to the D6 gear. No slipping anymore. You may have to sand the inner diameter a little. Clean up the print by drilling through the filament guide and smoothing the upper entry. I printed this in PETG but PLA or ABS will work just fine.

I can finally print large projects in Ninfaflex on the Wanhao D6 with this, a silicone boot and the Micro-swiss hotend for the Wanhao D6.

Empiricus@Dremomys

Print Settings

Rafts:

Yes

Supports:

Yes

Notes:

PETG, 0.150mm

Category: 3D Printer Extruders

Tagi