1 / 3
Wanhao D6/Monoprice Drive Block for Flexible Filaments — image 1
1 / 3

Wanhao D6/Monoprice Drive Block for Flexible Filaments

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Another take on a drive block for the extruder of the Zortrax/Wanhao D6/Monoprice Ultimate clonage for flexible…

Rating
0 / 5
Likes
9
Downloads
24
Makes
0
Views
296
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Another take on a drive block for the extruder of the Zortrax/Wanhao D6/Monoprice Ultimate clonage for flexible filaments.

Version 2 has a very tight fit for the 10.8mm diameter, 38 tooth Robotdigg Filament drive gear 4 flat shaft for nema17 stepper (RDGFDB) and the Micro-swiss lever for the Wanhao D6. The original D6 drive gear will also fit. The Robotdigg gear has wicked sharp teeth and thus much better retraction abilities compared to the D6 gear. No slipping anymore. You may have to sand the inner diameter a little. Clean up the print by drilling through the filament guide and smoothing the upper entry. I printed this in PETG but PLA or ABS will work just fine.

I can finally print large projects in Ninfaflex on the Wanhao D6 with this, a silicone boot and the Micro-swiss hotend for the Wanhao D6.

Empiricus@Dremomys

Print Settings

Rafts:

Yes

Supports:

Yes

Notes:

PETG, 0.150mm

Category: 3D Printer Extruders

Tags