IKEA Skadis Board Connector (T-Clip System)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A connector based on the T-Clip System to connect two Skadis aligned boards for stablizing the boards.
- Ocena
- 5 / 5
- Polubienia
- 103
- Pobrania
- 573
- Wydruki
- 7
- Wyświetlenia
- 2549
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
Print settings:
- Place the connector flat on the board.
- No support needed.
- I suggest 0.16 or 0.2 layer height.
Use T-Clip from original creator, depending on your board (painted or not). I suggest as the original Skadis T-Clip System creator to use tight tolerances to have the best effect for stabelizing your boards.
In addition I suggest to use my 90° degree version to stabelize it over a corner. Tried it on my childs desk and there is nothing loose anymore :): https://www.printables.com/model/802746-skadis-board-90deg-connector-t-clip-system
Currently available: 5 hole and 3 hole version.