Skinny Filament Spool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Half-width filament spool
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 281
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I made this model because I have a number of smaller filament samples that are just loose coils and I wanted to put them on spools, but not take up a full-size spool for each color.
This spool is about half the width (or a little less) than a standard 1kg size spool, so I can have two different colors in the same amount of space as one would normally take up.
There is a center over-lapping lip that can easily be hot-glued or super-glued to assemble it.
I added a third model that has an additional center ring for extra strength and makes the filament wind not so small. I just used hot glue on some of the points where it touches the top wheel.