Skinny Filament Spool
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Half-width filament spool
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 13
- Makes
- 0
- Views
- 282
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
I made this model because I have a number of smaller filament samples that are just loose coils and I wanted to put them on spools, but not take up a full-size spool for each color.
This spool is about half the width (or a little less) than a standard 1kg size spool, so I can have two different colors in the same amount of space as one would normally take up.
There is a center over-lapping lip that can easily be hot-glued or super-glued to assemble it.
I added a third model that has an additional center ring for extra strength and makes the filament wind not so small. I just used hot glue on some of the points where it touches the top wheel.