HWS Spice rack

An angled rack for holding spice jars that attaches to standard HSW honeycomb.

I built this to fit my Ender 3 S1 Pro (235x235 bed size (Thanks Thomas Toka for the firmware allowing use of the entire bed space!).  The rack part fits diagonally on the bed just right.

The bottom of the rack has 5 chamfered slots that the angled attachments slide into.  I've found using the two on the ends to suffice for me, but they were easy to add into the design if you need the extra strength or additional support.  They are a tight fit so it shouldn't need glue or anything to hold, but if you don't have your settings dialed in, it might not fit. 

I printed in PETG for sturdiness.  For the Rack I used .28mm thickness and .6mm width (works great even with .4mm nozzle), no brim or supports needed, but make sure the first layer above the slots runs lengthwise so they can bridge the slots easily without sagging.  The slots are offset intentionally so as to center the rack on a honeycomb that's 10 hexes wide.  If you want to bias to the other side just us the mirror ability in your slicer.

For the angled attachment parts, standard .2mm thickness and .4mm width work fine.  These parts fit into the original HSW dual hallow inserts to connect to the HSW.

For anyone wanting to modify you can see my (somewhat awful and convoluted) onshape modeling here:

https://cad.onshape.com/documents/2b7555a10426061fbf70a7ad/w/9d2ec13fed58d20349830d24/e/625f77f976c9784eb5eec7e0?renderMode=0&uiState=65f0b287426ba973ca6596a8