Power Cord Protector (UPDATED)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple snap on cover meant to protect the joint where two power/coax cables meet. Print in TPU!
- Ocena
- 0 / 5
- Polubienia
- 187
- Pobrania
- 196
- Wydruki
- 2
- Wyświetlenia
- 2364
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print in TPU!
(It has to be flexible in order to fit over a cord/plug.)
Check dimensions first. Resize Z is an option.
While this is NOT meant to be waterproof, I did add a long gasket and end plugs to make it a bit more tightly enclosed.
I iterated this a few times and ended up narrowing the cut along the side. On my last print, there was occasional stitching/spaghetti between the two sides that I cut with an xacto blade. Because this is a functional item, I'm not worried about the aesthetics, but if you are … you may want to do a partial print or calibrate your TPU or add a negative to widen the slot.
My settings:
- Vertical, no supports
- TPU 95A
- 0.28 layer lines
- 2 walls
- 5% gyroid infill (this is very minimal, you may desire more for strength/durability)
- Outer brims on
The gasket and end plug used the same settings. It was important to turn on THIN WALL DETECTION, because the end plug is a very thin (flimsy) single wall cylinder. As such, I left it to print intact and then cut it with scissors after printing.