BROFIST - BambuRefillableOwnFilterInsertSaveTime v1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a box for either replacing the Bambu filter with a refillable one, or for adding to the bottom of the chamber.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Give your Bambu printer a BROFIST - A direct replacement for the stock Bambu carbon filter in the X1C/P1S. It can also function as an added filter at the bottom sides. A bit of tape between the lid and box, then doubled over on the outside will serve as a pull tab. Or you can use tweezers. The world is your oyster! Save money by buying your carbon filtration material in bulk.
-----------------------------
To install in a vertical orientation at the bottom of the chamber (not required, but a nice option, you will need:
4x M3 Short heat inserts from CNC Kitchen
4 x M3x4mm TX10 bolts from CNC Kitchen (4 x M3x4mm Hex machine bolts should work, provided the heads are not deeper than 4mm total)
Heat insert tip to suit.
-----------------------------
Sliced and printed as pictured in the 0.20 Strength preset using eSun Black ASA with some minor changes:
Seam position - Back
4 Walls
4 Top & Bottom Shells
Top, Bottom and Solid Infill pattern - Rectilinear.
35% Adaptive Cubic infill
Enable Supports - Tree (auto)
Supports on build plate only
Support critical regions only
1 Top Interface Layer
-----------------------------
3mf file is set to my own filaments, using Polymaker Army Green ASA for support/raft base and Polymaker Orange ASA for the interface layer. Works fine as shown.