Shelly 1 / 1PM DIN Rail mount for Wago 221
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds one Shelly 1PM and changes the connectors to Wago 221 clamps for easy DIN rail installation (35mm).
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 201
- Wydruki
- 0
- Wyświetlenia
- 1328
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I reremixed the version of boinappi which is a remix of the magnificent design from Marc Neuhaus to fit a Shelly 1PM.
Heat inserts are very nice but unfortunately i don't have some ;-)
Will fit for Shelly 1 and 1PM, please be aware they switched the position of SW and I/L1
You will need:
- 1x Shelly1 / 1PM
- 4x Wago 221, 3 cable version
- 2x M4x10 cap or other head screws (select respective Din Mount version)
- 4x wire terminator, isolated (please use them)
- 30cm flexible wire
Shelly will not be flush with the holder and poke out 2mm or so. There is also no sufficient protection against touch.
Printed in PLA, 15% infill, 0.16mm, 0.4 nozzle
Changes:
Housing:
- M4 threads printed in place instead of heat inserts
- Labels are mirrored to avoid crossing cables inside
- Labels changed from negativ to positv (0.2 mm)
- Added a cutting at the bottom for easier installation
- Shelly logo added on the top
DIN mount version 1:
- Countersink holes added (5mm) for the M4 countersink screws
DIN mount version 2:
- Normal holes added (4.5mm) for cap or any other head M4 screws
