Ikea Platsa Filament Guide (134mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
EDIT : After a few months of use, it's working super good ! Be sure to drill as aligned as possible with the extruder,…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 254
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
EDIT : After a few months of use, it's working super good ! Be sure to drill as aligned as possible with the extruder, so your cable won't bend and it will reduce "plastic sliding" noise.
I glued the outer part just a little bit to make it stick well. Never had a single issue with that part !
I switched from Lack enclosure to Platsa enclosure that I find more beautiful and more convenient.
I used the Lack Filament Guide of 120mm but I drilled a hole a little bit too large, and the height of the wood part is thiner on the Platsa than on the Lack.
To have a nice finish, I printed this object two times : on the bottom and one for the top. As the height of the wood part is approx 21mm, I made the inner part of each to be 10mm.
The large raft around the inner part is made to hide the broken paint when I drilled.
To calculate where to drill, I put the printer in the right position, and went up as straight as possible (to avoid filament bending). The large hole (134mm) lets the filament go through the Y axis easily. If you print with PETG you might even have less friction.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.20
Infill:
10%
Filament: Colorfabb PETG Black
Notes:
I printed this without supports, basic PrusaSlicer settings for PETG, came out perfectly !
I printed 2 of them and it took 2 hours.
How I Designed This
I designed this part with OnShape
Category: 3D Printer Accessories