Ender 3 Filament Guide when using Bambu Spools with Clip Fitted
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small accessory to stop filament jamming when using Bambu Reusable Spools that have a filament clip attached.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 177
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you use one of the many filament clips that attach to Bambu spools, and want to use the spools on an Ender 3 (or other bed-slinger) printer, then this little adapter may be of use to you.
I did not expect that the clip I have been using on the reusable spools would have caused a problem on the Ender 3. I came to check on a print on my Ender 3 only to find that the filament had jammed under the clip (which I didn't think could happen). The Ender 3 tried to keep printing with the filament as tight as a guitar string (obviously the print failed).
My solution, make a simple removable adapter to clip onto the top rail of the bed-slinger. It can be positioned anywhere on the top rail and is simple to remove. I have decided to use it for my non-Bambu spools as well.
Printed versions in PLA and PETG - both worked well.