Guide Rail Wall Hangers for Makita Plunge Saw Tracks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall hangers for hanging your plunge saw guide rails / tracks on a wall. Fits Makita, Scheppach, etc.
- Ocena
- 5 / 5
- Polubienia
- 47
- Pobrania
- 341
- Wydruki
- 1
- Wyświetlenia
- 1898
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
These wall hangers hold either one or two Makita guide rails (tracks) for your Makita plunge saw (track saw)
Includes counter sunk holes for #4 (4.0mm) screws to fix to the wall.
IMPORTANT: The longer of the two hooks must go at the top when installing on a wall.
PRINTING: Print the model on its side for maximum strength, avoiding layer lines becoming a weak point. The example shown is printed in standard PLA.
First slide the rail (cutting edge side up) into the hanger and then lower the rail into the hanger. The Makita guide rails are stored with the logo upside down as shown, to protect the rubber cutting edge.
The hangers will also fit similar sized guide rails from other manufactures. Please share your make if you use them successfully with any brand.